answersLogoWhite

0

What is bleeding of turbine?

Updated: 12/19/2022
User Avatar

Wiki User

11y ago

Best Answer

Bleed air in gas turbine engines is compressed air taken from within the engine, after the compressor stage(s) and before the fuel is injected in the burner

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is bleeding of turbine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What best describes the operation of a waste gate turbo charger?

The waste gate controls the boost coming out of a turbo by bleeding off exhaust gases/pressure to the turbo's turbine. By control the amount of gases/pressure the turbine see's, it controls the turbo's speed/pressure.


What is HP and LP turbine expansion?

HP Turbine is High Performance Turbine LP Turbine is Low Performance Turbine


Would a turbine be a chemical or physical change?

Turbine is not a change, a turbine is a mechanical device.


What is difference between radial flow turbine and axial flow turbine?

in a radial flow turbine the steam enters the turbine in the direction of its radius and leaves it in the direction of the axis of the shaft. in a axial flow turbine the steam enters the turbine in the direction of the axis of the shaft and leaves the turbine in the same direction.


How do you spell turbine?

Turbine is the correct spelling.


Why would you not heat the steam coming out of turbine and feedback to turbine?

becouse this steam is use repetdly for the turbine


Gas turbine generator?

gas turbine generator


What is mix pressure turbine?

mix-pressure turbine


What is a turbine and how does it produce electricity?

what is a turbine and how does it produce electricity.


How much power do you get from a steam turbine?

Depends on the turbine


What the difference between extraction and bleeding in steam turbine?

bleed is amount of steam output from turbine through pipe and exit from final stage of turbine . this bleed enter to feed water heater (low and high) and deaereator to increase unit efficiency or rather bleed is the amount of steam drained out of the steam turbine during the expansion of steam and this rejected heat energy is used to heat the feed water supplied to the boiler...........


What was the first gas turbine car?

The Chrysler turbine car 1962-1964 was the first turbine production car.