Chloride is an ion. It cannot exist alone, but must be with some positive ion. Potassium chloride, sodium chloride, lithium chloride, copper (II) chloride, etc. are compounds and each has a certain density.
The density of Butyl Chloride varies depending on its form. Tert-Butyl chloride has a density of 840 kilograms per cubed meter, while 1-Chlorobutane has a density of 890 kilograms per cubed meter.
They are both fine white powder type crystals with high Mp's so I would go with density or molar mass. The molar mass of strontium chloride is 158.53 (anhydrous, and up to 266.62g/mol at it's most hydrated) and of potassium chloride is 74.55g/mol. You could so a density test but for that you must make sure to use the anhydrous form. I believe the density of strontium chloride is 3.05g/cm3 (when it is anhydrous) and potassium chloride is 1.98g/cm3. The problem with this is if stontium chloride's density can be recorded as low as 1.93 depending on how hydrated it is so in order to this accuratedly you must use the anhydrous form.
1.984
No because sodium acetate is soluble in water
Because of diffence density so you can use separated tank.
1. Because the density of sodium chloride is higher than the density of water. 2. Sodium chloride is soluble in water.
The density of Butyl Chloride varies depending on its form. Tert-Butyl chloride has a density of 840 kilograms per cubed meter, while 1-Chlorobutane has a density of 890 kilograms per cubed meter.
The density of sodium chloride is 2,165 g/cm3.
The density of sodium chloride is 2,165 g/cm3.
2.17g/cm3
Halite is the common form of sodium chloride. It has density of 2.165 g/cm3
Halite is the common form of sodium chloride. It has density of 2.165 g/cm3
The water density doesn't decrease.
The density of a pure sodium chloride crystal is 2,165 g/cm3.
This depends on the sodium chloride concentration; higher the concentration, higher the density.
They are both fine white powder type crystals with high Mp's so I would go with density or molar mass. The molar mass of strontium chloride is 158.53 (anhydrous, and up to 266.62g/mol at it's most hydrated) and of potassium chloride is 74.55g/mol. You could so a density test but for that you must make sure to use the anhydrous form. I believe the density of strontium chloride is 3.05g/cm3 (when it is anhydrous) and potassium chloride is 1.98g/cm3. The problem with this is if stontium chloride's density can be recorded as low as 1.93 depending on how hydrated it is so in order to this accuratedly you must use the anhydrous form.
1.984