A"drain pump" machine uses a drain tube that is higher than the the level of water in the basin and therefore uses a mechanical pump to empty the tank overthat threshold pipe. A "dump valve" drain uses a mechanical valve at the bottom of the basin and simply opens to drain the tank.
drain pump is higher then drain value is machanicle value
You can drain it directly into a drain pipe. Just make sure the the top of the drain pipe is even with the top of the washing machine. If not, the water from the washing machine will drain all of the time. There is no valve in the machine to stop the water from draining. The washing machine drains using a pump motor.
Backflow from the sewer or drain pipes.
No, cold wter enters the water heater at the bottom of the tank, right where thee valve is.
It's a valve that allows you to drain the water from a jet ski. It's used after washing the bilge or to drain the bilge after riding.
It depends on whether or not your drain line is threaded at the top of the pipe. Older homes like mine have a threaded line but newer homes have a smooth line.
The washing machine is pumping out water faster than the drain pipe can handle. A trap in the drain pipe to which the washing machine hose is attached is required and that makes the water flow slower than you might expect. Having the washing machine some distance from the main drain line requiring a long horizontal run in the machine's drain pipe will also result in a slower flow. Other causes could be: undersized waste pipe, backward wyes or santees, backgraded piping, backed up gray water system. An obstruction such as a checker piece or poker chip could be lodged within the pipe. Such an obstruction acts as a valve or flap that will pivot out of the way when a snake is pushed through the pipe but pivot closed when water attempts to flow through. Nowadays a two inch drain pipe is recommended. Some cities require two inches or larger. Do not seal around where the washing machine hose is hooked onto the drain pipe as this could overload components within the machine.
The manufacturer of the genesis valve is: JDJ Valve CompanyP.O. Box 206Troy, TX 76579Phone : (254) 938-7678 You can buy it retail from: Staas Plumbing Temple, TX (254) 778-2575 Regards, Dennis/Waco, TX
never
Washing machines should be trapped.
This is a great video on how to take apart the washing machine. In reverse order, he shows you parts of a washing machine. Check out the instructions here: http://www.mindbites.com/lesson/425-fix-washing-machine
Yes ! If it is not fully open,or horizontal. Cheers.....Dave
It doesn't pump the water in, where the hoses attach to the washing machine is a valve that opens and lets the water in. The pressure in the line forces the water in the same way it does when you turn on a faucet.