The candela measures luminous intensity, whereas the lumen measures luminous flux. In simple terms, you can think of luminous intensity as being similar to 'brightness', while luminous flux is similar to the rate at which light leaves its source.
1 lumen = 1 candela per steradian.1 candela = 1/683 watts per steradians (assuming 540nm light wavelength).Assuming that the light is collected from a single steradian:1 Lumen = 1 Candela -> = 1/683 Watt -> Watt = 683 Lumens1 Joule = 1 Watt per Second -> Watt = Joule/SecondHence:683 Lumen = 1 Joule/SecondUnder the above assumptions1 Lumen = 1/683 Joule/Second
The second.I see the "second" as a measure of time, not light.LUX, Lumen or Candela do ring a bell and something like watt per square meter..Yes the S.I. unit measure of light is a limen (lm) .lumen (lm)The SI derived unit for measuring the luminous flux of light being produced by a light source or received by a surface. The luminous intensity of a light source is measured in candela. One lumen represents the total flux of light emitted, equal to the intensity in candela multiplied by the solid angle in steradians (1/(4pi) of a sphere) into which the light is emitted. Thus the total flux of a one-candela light, if the light is emitted uniformly in all directions, is 4pi lumen.
I don't believe that there is such a thing as an 'ampere per lumen'. An ampere is the SI unit of current, whereas the lumen is the SI photometric unit for luminous flux. There is no direct relationship between the two.
Intensity is measured in Candela. Candela is its SI unit.
This question is ill posed. Lumen is a unit of measure for how much light comes from the lamp Watt is a unit of measure for how much energy is used by the lamp If the question were; "Which is brighter, a 2000 lumen bulb or a 1500 lumen bulb?" then the answer would be: The 2000 lumen bulb. I think the relation ship between lumen and watt is something like: Incandecent bulbs are 15w/lumen Flourecent bulbs use 40w/lumen LED bulbs are 70w/lumen The way to show the watt and lumen relationship is usually lumens (amount of light) per watt (energy consumption). This is like gas in your car (Miles or KM per Gallon or Liter). Incandescent bulbs have a maximum luminosity of 52 lumens/watt. Fluorescent bulbs range from 46 lumens/watt (CFL) to 100 lumens/watt (T5 and T8 tubes) LED bulbs range from 29 lumens/watt (older, low efficiency) to 100+ (XCree) and they are getting better.
Candela are units of light intensity, while kelvins are units of temperature.
1 lumen = 1 candela per steradian.1 candela = 1/683 watts per steradians (assuming 540nm light wavelength).Assuming that the light is collected from a single steradian:1 Lumen = 1 Candela -> = 1/683 Watt -> Watt = 683 Lumens1 Joule = 1 Watt per Second -> Watt = Joule/SecondHence:683 Lumen = 1 Joule/SecondUnder the above assumptions1 Lumen = 1/683 Joule/Second
arteries 've short lumen where as veins 've large lumen.
An oriphice is a hole that joins two chambers on either side of a wall whereas a lumen is the space within a tube
Ash is a split lumen, the Quentin is one lumen different out/in holes for each port on the same lumen. Do the same type of thing, just different execution.
The second.I see the "second" as a measure of time, not light.LUX, Lumen or Candela do ring a bell and something like watt per square meter..Yes the S.I. unit measure of light is a limen (lm) .lumen (lm)The SI derived unit for measuring the luminous flux of light being produced by a light source or received by a surface. The luminous intensity of a light source is measured in candela. One lumen represents the total flux of light emitted, equal to the intensity in candela multiplied by the solid angle in steradians (1/(4pi) of a sphere) into which the light is emitted. Thus the total flux of a one-candela light, if the light is emitted uniformly in all directions, is 4pi lumen.
The lumen is the unit used to measure the rate at which light energy is radiated from a source. The lumen represents the international standard unit of luminous flux that is based on the candela.
Arteries are more elastic but have smaller lumen. They carry blood away from the heart. Veins are less elastic have larger lumen and have valves. They carry blood to the heart.
Cillia is found in the trachea whereas villi/microvilli is found in the lumen of the small intestine
Foot Candela is the measuring unit for illuminance while candela/meter squared is a measuring unit for luminance,which makes conversion not possible. conversion can be done for units of the same quantity, for example, illuminance units : ft candela = 10.764 lux. To know the difference between luminance & illuminance, you can take a look at http://www.tpub.com/content/gsacriteria/gsa_courtroom_lighting/gsa_courtroom_lighting0012.htm
Polyps extend from the mucosa into the lumen of a hollow organ. Papillomas are epithelial tumors are project ouwards.
I assume you mean candela seconds vs candelas per second. The first is derived by multiplying candelas by time, the second is achieved by dividing candelas by time