What would you like to do?
Answer a gate valve has a section inside that moves up and down to close off the flow. Metal on metal. A stop valve uses a rubber washer to seal the flow.
They serve two different purposes. An air bleed valve is used to remove air from the circulation system. A pressure relief valve is designed to automatically open when certain… pressure levels are reached.
Control valve: Used to modify flow rate in a process control system.It has characterization: linear,equal percentage and quick opening Pressure inlet must be higher than the… output pressure Regulator:Diapghram operating valve which controls outlet pressure (reducing application),control inlet pressure (back pressure) or either (differential reducing and differential relief applications
actuator is a mechanism that will responds to hydraulic,pneumatic and electrical signal ,it is used to control the valve that to be in open or close condition.
The Gate valve is the stop valve & the Globe valve is the fluid Regulating valve.
valves are use in four stroke engine, and ports are use in two stroke engine.
A valve is a structure in a hollow organ (like the heart) with a flap to insure one-way flow of fluid through it whereas a sphincter is an opening of skin and surrounded by mu…scle that physically restricts and controls the passage of substances through the digestive tract. There are three main sphincters in the digestive tract: the esophageal sphincter, the pyloric sphincter and of course the anal sphincter.
Some valves lie between the atria and some valves lie between the atrium and the ventricle
The heart has four chambers. Deoxygenated blood enters the right atrium from around the body via the superior and inferior vena cavae, and travels down through the tricuspid v…alve into the right ventricle. The right ventricle pumps the deoxygenated blood to the lungs to be oxygenated, via the pulmonary artery (the only artery that carries deoxygenated blood). It returns via the pulmonary vein (the only vein that carries oxygenated blood) into the left atrium. Oxygenated blood then enters the left ventricle (the heart's principle pumping chamber, and has particularly thick muscular walls) from the left atrium through the mitral valve. The left ventricle pumps the oxygenated blood at sufficient pressure to travel round the entire body, through the aortic valve and into the aorta. - Qu.mstr.
A non return valve is used mainly on fluid pipe, which uses gravity and the fluid to close it. A check valve is normally spring loaded to ensure a positive seal and will need …a greater delta P to open. Also check valves are normally used with gas.
A capilliary is a minute blood vessel - a valve is something found usually in a vein or artery - which stops blood flowing 'backwards'
Smart valves produce gas faster
In globe valve we just handle small amount and small pressure of fluid while in gate valve we can handle a large amount and large pressure of fluid.
The purpose of both the valves is same - that to maintain a certain level(in a vessel or tank...) Simple Level valve could be referred to an ON - OFF valve where as control va…lve could be referred to an analog type of valve. On - OFF valve is for a crude control of level, while control valve is used where a fine level control is needed.
i believe the reflux valve is just a type of check valve, the flapper type.
An air valve is a spring loaded plastic valve for ventilation. A gate valve is an old fashioned type of water valve where turning a handle lowers a blocking gate over the wate…r inlet. Any sensible plumber now uses ball valves instead.
For Butter Fly valve Stopping and starting flow Moderate throttling Flow diversion and for Gate valve Stopping and starting flow infrequent operation. -----------------------…---------------------------------------------------------------- A butterfly valve is a balanced valve, meaning it can be opened with minimal effort despite there being pressure exerted on it. It is not a positive shut off valve, meaning even closed some fluid can leak through the valve. They are often used for solid granular medium control, such as on grain chutes or powder filled hoppers, as granular solids do not need a positive shut off valve to stop their flows. Butterfly valves can be manually set partially open, or be controlled automatically to throttle or control flow volumes. A gate valve is a positive shutoff valve, is not balanced, thus can be difficult to open under pressure, used specifically to isolate fluid lines, do not leak, unless worn out, and should not be set partially opened to control fluid flows, they must be opened or closed fully to prevent damage.