3m epoxy part number 08641
Silicone and any epoxy will hold in water
Window regulator and motor
C:/System Volume Information.
it sounds like you need a new window regulator
Revise your question--- on what? Power windows? motor regulator assembly?
To replace the regulator on a 2006 Ford Fusion, you must engage a mechanic.
If they aren't closing all the way and you have manual windows you need to replace the regulator. If you have electric windows the gears in the window motor need to be replaced.
REMOVE THE DOOR PANEL once the door panel is off,disconnect the harness that is hooked to the power control switch, windows etc, after that you will see maybe 2-3 bolts on the door which holds the window regulator, unbolt those be careful of the window, you should have some screws that hold the glass to the regulator bracket, unscrew those to release the glass, you may want to use something to prop it up so it dont break, once you unbolt it slide the entire unit out, you will see the regulator and the motor, just unbolt the regulator and put the new one in and reverse the procedure.
apps
Channel? Regulator? It is a regulator clip. I just recently replaced mine. You can get them online at GM parts direct.
Window regulator controls the up and down motions of your car window. Both electric and manual windows have a window regulator. Not the easiest part to replace, but once you dissembled the door panel it should be fairly simple to replace.
The presser foot is a special part of the machine that holds the fabric down so the stitches remain even. I have not seen a pressure regulator on a home sewing machine.