Want this question answered?
Emitter-Base junction should be forward biased.Collector-Base junction should be reverse biased.
For a transistor to be in active region : Base Emitter junction should be forward biased and Emitter collector junction should be reverse biased.
a transistor in active region when emitter junction is forward biased nd collector junction is reverse biased
To know if a transistor is PNP or an NPN,the following should be verified:For a PNP transistor, the base-collector junction is forward biased while the base-emitter junction is reversed biased.For an NPN transistor, the base-emitter junction is forward biased while the base -collector junction is reversed biased.
A very high speed bipolar junction transistor having a metal-semiconductor emitter base junction instead of a semiconductor-semiconductor emitter base junction.
It depends on the transistor. Minimum base-emitter junction voltage can be as low as 0.6 volts for a silicon transistor, and as low as 0.2 volts for a germanium transistor.
Emitter biasing is when you add a resistor between the emitter of a transistor and the 0v rail so that any voltage developed across the emitter will subtract from the voltage on the base and effectively turn the transistor OFF. We are talking about an NPN transistor and the transistor is an "ordinary transistor" or BJT (bi-polar Junction Transistor). For more information on transistor biasing see: Talking Electronics website.
The question is poorly phrased and needs a grammatical cleanup. If you mean to ask "what happens to the collector-emitter current of a transistor when the emitter-base junction is reverse biased" then the answer is that the transistor will turn off, and you will only see leakage current.
Resistor placed in the emitter lead of a transistor circuit to minimize the effects of temperature on the emitter-base junction resistance.
Assuming you mean a bipolar junction transistor (BJT): 1. Reverse bias on the collector-base junction. 2. Forward bias on the base-emitter junction, that is 3. Sufficient to give the correct operating point of collector voltage/collector current.
Yes1
In order for a transistor to operate as a switch, the base-emitter current must be greater than the collector-emitter current divided by a factor of hFe. In this state, the transistor operates in saturated mode, fully turning on.