The starter solenoid is most likely bad if it will not crank over If it cranks over most likely crank sensor is bad how can you just say most likely the crank sensor? how the hell do you know it could be anything
Check the wiring on the starter. Also check all grounds
If the starter spins but won't engage, then the Bendix is not engaging the flywheel. Remove the starter and test to see if the Bendix thrusts out, and check to see that the flywheel does not have chipped teeth.
It depends... by Seize do you mean that the engine is locked up and wont turn at all. It could be a starter failure as if the starter went out or the Starter Solenoid causing the starter not to work or engage and by it not working or engaging it wont turn the engine over to start the vehicle... if it is turning over you have to check to see if your receiving fuel, then if you are, check for spark.
Starters are made specifically for certain engine and transmission combinations. The snout of the starter must be the correct length for the worm gear to engage the ring gear. If you have the wrong starter, the worm gear will not engage properly. If the ring gear is damaged, the starter might be operating properly, but have no teeth to engage. If the solenoid is not working, the starter motor will spin, but the worm gear will not be pushed forward to engage the ring gear. Remove the starter, and visually check the ring gear for missing teeth. If the ring gear appears to be intact, take the starter back to the place where it was purchased and have it tested. If the starter tests good, check the solenoid wiring on the vehicle to insure that the solenoid is being energized. If all of these steps fail to identify the problem, return the starter and get a different starter out of stock and compare them. You might have a mislabeled starter.
Check battery power should be round 12volts if ok, need to check if you have power to stater when you turn the key ( ie test light on starter wire ) if ok possily of a worn out starter, remove starter, test starter, if starter is ok, need to see if you can turn the engine over buy hand
1) Check you're owners manual for fuse locations! 2)A new starter does not turn engine??? - Check fuel - Check for spark - Check battery 1) Check you're owners manual for fuse locations! 2)A new starter does not turn engine??? - Check fuel - Check for spark - Check battery
Check the connections at the starter, and at the battery. If they are good, remove the starter and have it bench tested at an Auto Parts Store.
The usual issue with a 2005 Saturn Vue engine light is a problem with the EGR valve. It is best to have a mechanic check out the problem.
easiest wat to check a starter is to turn on ignition.then with a screw driver cross the positive lead to starter wire on the starter motor if the starter is good this will turn over the engine if starter is bad it will not if this does tuen over engine , you can then check solenoid and other ignition parts
check starter motor
Check your battery
It is possible that a Subaru Check Engine Code #12 is a bad starter switch. This is usually the starter relay switch malfunction code for Subaru.