0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
WHAT DO the letters MTR's mean in welding terms?
MTR in welding?
How to avoid surface concavity in autogeneous welding?
Do you mean your beads are concave and you would like them convex in appearance while autogenous welding is being done? Without knowing what metal you are welding or seeing the technique used I can only offer generalizations. It could be a lack of sufficient sulfur or improper travel speed. Without more info I'm only guessing.Which isn't good when it comes to welding.
What is mean by cswip 3.1 welding inspector where is it?
it means welding inspector exam details
What is welding fault of lack of fusion?
It's when the different metals parts haven't melted together properly
What mean by anchor bar in beam reinforcement?
the top reinforcement of beam (compression face of beam). it is provided to hold the stirrups in place.
What is the meaning of 6g position in welding?
The meaning of 6G position in Welding is mean that the pipe or test piece inclined to 45 degree and not rotated during welding process .
How do you do nonfushion carbon arc welding?
Contradiction in terms. If its "non-fusion" then it isn't welding. You probably mean brazing.
What does extinction mean in relation to motivation?
The absence of any reinforcement following a behavior. Usually extinction occurs in situations where positive reinforcement was formerly applied.
What does R10-300 ties mean?
R10 reinforcement, at every 300mm
What are the main causes of welding accidents?
The main causes of accidents using welding equipment is lack of care during safety procedures. It is important when dealing with dangerous equipment to also follow the correct safety steps.
For Visual Reinforcement Audiometry what is the purpose of reinforcement?
reinforcement is video
What is the difference between gas welding goggles and arc welding goggles?
If by gas welding you mean-oxyacetylene welding. The difference is just that arc welding requires a darker shade of lens. When oxyfuel gas welding (OFW) usually a shade 5 lens is recommended. When arc welding, a minimum of shade 10 lens should be used (actually shade should be determined by amount of current used).
