answersLogoWhite

0


Best Answer

There has to be a tank pan under the hot water tank with a drain hooked up to the pan. If the tank leaks, it will go into the pan which will flow into the pipe that you have to have hooked up to the sewage system.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What plumbing is required to install a hot water tank on second floor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you convert toilet plumbing to accommodate shower plumbing?

You have to take the floor apart and reduce the piping to 2". You also have to install a p-trap as there are NEVER p-traps under toilets. All p-traps are BUILT into toilets!!!


How do you move a toilet to new location in a mobile home?

The toilet itself is easy to install but the plumbing would have to be rerouted by a professional. You just drill the floor and it's 2 bolts.


What is the first step to install a basement bathroom?

Decide if it is feasable. Are there drains already in place ? Does the existing main drain go through the floor or out the wall. If it's out the wall, you would need to install a pump for the sewage. If it is through the floor, you will have to bust out a section of the floor to install drains if none exist. Fairly expensive and labor intense. so you have to ask if it is worth it. After the drains are dealt with, it is just a matter of walls, plumbing, and fixtures.


What are plumbing Rough-in stops?

Roughed-in plumbing refers to plumbing (water and waste lines) installed for future fixtures, for example, a bathroom in a basement. Stops refer to shut-off valves on water supply lines, required to shut-off the water to repair the fixture that they service. So "Rough-in stops" are shut-off valves on supply lines that are roughed-in. If they were not roughed-in, you would need to break concrete floor (to install waste lines) if/when you decided to add a bathroom to your basement family room.


Can I replace a bathtub and install a shower?

Yes, this will be an easy switch because the proper plumbing is already in place. You will just need to remodel the area where the tub was because the floor underneath will probably not have any tile on it.


Would adding a clothes washer to a second floor condominium unit impact the plumbing of the condo unit directly beneath the second floor unit?

it depends on how your lines run. usually it woulden't effect anything but if your sewer line is to close to some of the fixtures in the upper floor the suds from the washer could back up into the other fixtures.


Is cast iron required on all 3 levels of a residential home even if the third floor has no plumbing fixtures?

No PVC is acceptable, you can join the new PVC piping into the existing Cast Iron.


Can anyone recommend a good Arizona plumbing company for large jobs?

Mesa Plumbing Company is a good Arizona plumbing company. This company can replace the entire plumbing system in your house and add a half bath on the first floor.


Where to buy perforated steel tape?

plumbers tape, for securing plumbing pipes to wall /floor stus etc. try a plumbing supply.


Can you install ceramic tile on top of a wood floor?

If it sits over a cement floor, then no. If it is a nailed down floor, then you can, but you still have to install a cement board.


How do you determine height of toilet flanges and floor drains prior to the concrete being puored?

By strict calculations OR install the pipe longer then needed and after the finish work cut the pipe to the required height and install the flange


Do you install the vanity or tiles first in the bathroom?

You should install the tile floor first. Install tiles on the entire floor, even under where the vanity will go.