Standard meter will suffice, need to know pressure from meter to house. Size pipe appropriately for gas pressure coming into house X distance to water heater. Gas company or plumber should be able to help with this calculation.
2,690.9776 ft2
Answer: 102 m² = 1,097.918 ft²
620 (square meters) = 6,673.62 square feet.
250 square meters is 2,691 square feet.
300 (square meters) = 3,229.2 square feet.
The gas meter on your house is sufficient,
If your furnace is less then 50000btus then yes.
Check with your utility company; you may have other gas utilities in use as well.
The actual cost of a reputable brand name tankless unit and the necessary unit accessories will cost approx. $800-$1500. Then you have the installation costs. A realistic installation cost in the Los Angeles area for a Gas tankless is between $1,000 and $5,000. The costs vary greatly because of the need to most likely upgrade the gas line, meter, vent, and often relocation of your water heater. My average installation costs have been around $1500, but i have installed a few that have been closer to the $4000 range.
It is probably right next to the water heater. There should be a shutoff at the floor, if not then at the meter is the most likely shutoff.
meter, heater, teeter, seater
Not unless the water line is cut on the cities side of the meter. Even that is doubtful because the meter should be one way and not allow house water to get back to the main line.
There should be a shutoff at the wall where the water line enters the house. There may be one before the water heater or there will be one at the water meter.
Some words that rhyme with "heater" include meter, cheater, and sweeter.
There are a few different places that an electricity meter on a house could be located. Typically an electricity meter is either around in the back area of a house or located to the side of a house. Sometimes an electricity meter can be found immediately to the front of a house property.
Ralph A. Van Meter House was created in 1957.
If some installation instructions came with the water heater which tell you what kind of wire to use, the same instructions should also tell you how to connect the wires to the water heater. As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.