You should not use regular PVC glue at lower temp than about 40f. -The glue is too thick and will not make good bonds this cold. -Weld On 725 is recommended for lower temperatures.
Colder than 10c - 50f , the glue becomes almost unusable.
I don't understand why you'd want to do that . CPVC glue is expensive, PVC glue is cheap and glues PVC pipe better.
its glue spicily for pvc pipe only
if your waste pipe is PVC and your glue is for PVC . yes! but make sure to use a primer(cleaner) on the pipe first.
NO, PVC is very sensitive to which glue is used. In Domestic pipe applications you should use Weld-On 711
Abs to PVC glue sold at home depot Color it aqua blue/green plumbers key term. GUMBY GLUE Depends upon what you mean by "black pipe". If you mean ABS drain pipe, there is glue for that. If you mean steel "black pipe", i.e., non-galvanized, then you would need a threaded connection adapted to the PVC (either a female PVC connector on a male black pipe or a male PVC connector into a female black pipe fitting). The secondary question would be, "Why would anyone want do to that?"
ABS yellow glue is the correct glue for ABS pipe. The only other glue to consider is Weld On Transition cement if you are gluing ABS to PVC parts.
A PVC pipe glue will take at least 4 hours to dry. 12 hours before putting water pressure in it.
Yes, you can. You need PVC glue though - 711 is best
PVc glue is a specialised item for gluing PVC pipe, with a primer. It MAY glue other household items, but test first and don't expect too much. It's not made for 'other items'
Use teflon tape with a little pipe dope. If you don't ever have to take apart again then you can use glue which you are calling cement
It depends on the size of PVC. For smaller PVC you can buy fittings that glue onto the PVC and allow a thread x barb fitting to be installed. For larger pipe you should get a brass compression fitting that clamps down on the PVC and adapts to a thread x barb fitting.
No, do not use glue. Use teflon tape or pipe dope on the threads. You should also make sure you always put the male PVC thread into the female metal thread. If you do it the other way you will tend to split the PVC fitting when you tighten the threads.