answersLogoWhite

0


Best Answer

Back when that tractor was made, they probably said to use an SAE 10 or similar hydraulic oil. Now days, the Universal Hydraulic Oils that are available meet and exceed the specs on those older type oils. You should be able to get Universal Hydraulic Oil from about any oil distributor or farm supply store.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What type hydraulic oil does a Case 530 tractor use?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

What is the average monthly cost for sewage?

$530


What does am frequency stand for?

AM stands for Amplitude Modulation. In theory, amplitude modulation could be applied to a radio signal on any frequency but the AM band on most domestic radios stretches from 530 to 1700KHz.


What is the cu cable size in 400a load?

A 0.15Cu cable has a rating of 382 amps summer and 476 amps winter. 0.2Cu allows 425/530 amps. That is for outdoor use in overhead lines.


What is the density of Baltic birch plywood?

The birch veneer is actually accounts for a small portion of the plywood's density. The core layers are more important. The Purebond plywood that I see at my local home despot is probably from Columbia Forest Products. According to their website, my plywood on the east coast is composed of a combination of aspen and fir layers. Birch has a density of 670 kg/m3, Aspen 420 kg/m3, and Fir 530 kg/m3. If you don't know what kg/m3 means, I did an estimate on the math. Guessing that the board is 2/3 Fir and 1/3 Aspen, and neglecting the millimeter of birch on top, the weighted average density is 494 kg/m3 or about 31 lb/ft3. If you still don't know what lb/ft3 means, basically a 4 by 8 sheet of plywood, 3/4" thick, should weight about 59 pounds. A half inch thick sheet, should weight about 39 pounds; and a quarter inch thick sheet should weigh in at around 18 pounds.


What is the height of the Sydney Harbour Bridge?

( A bridge was designed as a vertical curve above a train line according to the gradients (g 1 =+3.6%g g 2 =-2.9%) , if you know that the designed length of the bridge equal to 530 m find the following : a) Rate of change in gradient for each station . b) Elevation and station for each of intersection and end points if you know that the elevation and station of start point are 34.5 m and 23 + 00 respectively . c) Check if the design is ok if you know that the level of train line is 35.00 m and the minimum allowable height of the bridge at mid -point is 5.2 m