0
What would cause a ecm b fuse on a 2000 gmc sierra to continually blow?
Wiki User
∙ 16y ago
on gmc's and chevy's there is a spot in the wiring harness that goes down the back of the engine block on the passenger side next to the distributor, this section of harness continuously rubs on the back of the block, more so if an intake manifold gasket was just replaced. it will rub a hole in the wiring loom and ground out there. check it out and see.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Fuel sensor 2000 GMC sierra?
Yes, there is a fuel sensor in a 2000 GMC Sierra.
What would cause a 2000 Mazda 626 4 cylinder check engine light to stay on while automatic transmission continually down shifts from over drive?
get your transmission checked out. these transmissions are well known to fail
What would cause speeds 1 and 2 not to work but the rest are fine on a 2000 gmc sierra pu fan control?
most likely a bad resistor but possibly the switch. do a continuity check to tell for sure.
Where is the obd connector on a 2000 GMC Sierra?
The 2000 GMC Sierra OBD 2 port is on lower edge of dash; right of parking brake
What would cause my 2000 GMC Sierra 1500 volt gauge to start out at 11 volts at startup and then go to 14 volts after idling for a while?
Slipping alternator belt Loose connection Bad alternator Computer problem
How do you remove an airbag from a 2000 GMC Sierra?
you dont
Mpg for 2000 sierra?
14 or 15 Mpg
Why my 2000 gmc sierra VORTEC hard to start?
Your 2000 GMC Sierra Vortec might be hard to start because the battery or the starter are worn or dead. The GMC Sierra might also be hard to start because of a clogged fuel filter.
What weight oil goes in a 2000 GMC sierra?
5W30
What is the lug pattern on a 2000 GMC sierra 1500?
6x5.5
What is the fuel capacity of 2000 GMC sierra?
35 Gallons
What actors and actresses appeared in Infierno en la sierra - 2000?
The cast of Infierno en la sierra - 2000 includes: Valente Pastor Guillermo Quintanilla Antonio Raxel
