When the stopper is removed from a partly filled bottle containing solid and liquid acetic acid at 16.7 °C, a strong vinegar like odor is noticeable immediately. How many acetic acid phases must be present in the bottle? Explain.
Since the difference in volume corresponds to the volume of the stopper, the volume of the stopper=30.9-25=5.9ml Thus density of the rubber stopper=mass/vol=(8.46/5.9)g/ml
Styptic pencil is a bleeding stopper.
If the stopper is left in place while liquid is draining a vacuum will be created in the separatory funnel and outside air will try to get in. The only way it can do this is through the opening that the liquid is trying to leave. The air pushes against the liquid and will greatly reduce or even stop its flow. If the stopper is removed no vacuum is created because the air can easily get in the top of the funnel.
The Crystal Stopper was created in 1912.
Decanter
Since the difference in volume corresponds to the volume of the stopper, the volume of the stopper=30.9-25=5.9ml Thus density of the rubber stopper=mass/vol=(8.46/5.9)g/ml
it is stopper =]
Styptic pencil is a bleeding stopper.
A grenade, petrol bomb, a glass bottle containing petrol as fuel usually with a source of ignition such as a burning cloth used as wick and also acts as a stopper.
The Crystal Stopper was created in 1912.
Janina Stopper is 157 cm.
If the stopper is left in place while liquid is draining a vacuum will be created in the separatory funnel and outside air will try to get in. The only way it can do this is through the opening that the liquid is trying to leave. The air pushes against the liquid and will greatly reduce or even stop its flow. If the stopper is removed no vacuum is created because the air can easily get in the top of the funnel.
A CORK stopper is a plug for a bottle made of cork
The past tense of stopper is stopped.
If there is debris on the stopper it might be preventing a good seal. Try removing the rubber stopper and wipe it off to remove any debris that might be on it. Clean out the hole that the stopper goes into as well. This will help ensure a clean seal between the hole and the stopper. Put the stopper back into the hole, making sure it is a tight fit. If it still leaks you may need to buy a new stopper.
On most push/pull stoppers the knob part that you pull on unscrews from the stopper, and under that is a slot for a screwdriver tighten or remove the stopper. On stoppers with non-removable knobs, there is a screw (usually phillips) under the stopper which can be accessed with the stopper in the up position and unscrewed to remove the stopper.
Juan Stopper Sanchez was born in 1941.