The black hose hooks up to the air-intake box that is bolted to the radiator brace. It is part of the emissions stuff. I bet you have beacoup oil on engine from this hose, if its not attached. It will also affect the way the engine runs. AJ
The Pokemon on the front cover of Pokemon Black is Reshiram.
its on the right side when facing front[driver side] of the car behind the battery it will have a black cover and it has thick vent tube running to the engine remove the cover and replace
Lift the bonnet and at the very front of the engine, there is a long black plastic box running across the engine bay. The cover is held on by 8 screws.
Not sure *which* light cover is being asked about, but the "Related Questions" below will cover all 3: headlight, taillight & running light in the front bumper cover
It cannot be removed completely. The front of the cover is held in place by a plastic clip pin that can be pried off, then the front of the cover can be bent down to allow access to the bulb and wiring.
No, unless you are threatening it. The old "black cat running in front of you means that you will have bad luck" thing is superstition.
under the black front cover behind the headlights.
You have to remove the black plastic cover that is in the center of the valve cover. 4 bolts the two you see and if you look at the black box part at the front of the valve cover you will see the other two bolts. Take all 4 bolts out, remove the black plastic cover and you will see the spark plug wires. Good You have to remove the black plastic cover that is in the center of the valve cover. 4 bolts the two you see and if you look at the black box part at the front of the valve cover you will see the other two bolts. Take all 4 bolts out, remove the black plastic cover and you will see the spark plug wires. Good
R 134A freon is added into the "quick connect type" fiiting, located on top of the AC accumulator, which is located underneath the front of the passenger side fenderwell. First, raise the car with your jack placed behind the front tire. Then remove three screws that secure the black plastic fenderwell cover. One screw has a torx head and is located at the front lower edge of the fender. The other two are Phillips head plastic screws located in front of the strut. With the three cover screws removed, pull down the front portion of the fenderwell cover. This will expose the AC accumulator, which looks like a quart sized aluminun can. Now, unscrew the valve cover from the quick connect fitting and connect your AC recharging hose to the fitting. By the way, it pushes on and snaps onto the fitting. Now, follow the instructions that came with your AC recharge kit, for the dtermining the corrct amount of freon to add. Finally, replace the fitting valve cover, the fenderwell cover/screws and your done.
On the drivers side in front of the cross member. You have to remove the black plastic cover to get to it. It faces the front of the car.
Its under the hood dead center under the front cowl cover with a black protected cover......
Easy as pie. Remove the 2 black nuts at the front of the cover. Pull up the front edge and swivel the rear edge out of the clip that holds it down.