0
Where is the shift sensor or vacuum modulator on 1995 Pontiac Bonneville?
Wiki User
∙ 12y ago
evidentually it is a big secret. They will only tell you where to go to buy one.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you change transmission modulator valve in a 97 Pontiac Bonneville?
To change the transmission modulator valve in a 97 Pontiac Bonneville you will first need to lift the vehicle off the ground. Then, remove the vacuum hose and the defective valve. You can then replace with new, and replace the hose.
Where is vacuum modulator on a 2000 Pontiac Montana?
The 2000 Pontiac Montana does not have a vacuum modulator installed on it. Instead, it has an electronically controlled transaxle.
Where is the vacuum modulator on a 2001 Pontiac Montana?
2001 Montana has an electronic transaxle. There is no vacuum modulator. The 2001 Montana has an electronically controlled transaxle. There is no vacuum modulator.
Where is the vacuum modulator located on a 1999 Chrysler Sebring 2.5 jxi?
The transmission does not have a vacuum modulator.The transmission does not have a vacuum modulator.
Where is the vacuum modulator on a 1999 Chrysler Sebring 2.5l?
The transmission on a Chrysler Sebring does not have a vacuum modulator.The transmission on a Chrysler Sebring does not have a vacuum modulator.
How do you find a transmission vacuum modulator for a 1991 Chrysler new yorker?
The transmission in a 1991 Chrysler does not have a vacuum modulator.The transmission in a 1991 Chrysler does not have a vacuum modulator.
What is a vacuum modulator?
On some of the older vehicles the vacuum modulator controlled the shift points of the transmission by using the vacuum supplied from the engine.
How do you adjust a vacuum modulator?
I assume your refering to the vacuum modulator which controls transmission shift points. Remove the vacuum hose from the modulator. Using a small screwdriver, turn the screw inside the modulator. It may take several tries to get it right.
Is there a seal at the end of the vacuum modulator?
There should be an o-ring where the modulator is inserted into the transmission. There should be no fluid where the vacuum line attaches, if so the modulator is bad.
What does a vacuum modulator do?
A vacuum modulator is used to apply pressure to the throttle valve. The modulator senses the pressure from the manifold and increases when the engine is under a heavier load.
Does the transmission have a modulator valve?
as far as I understand , it does not have a modulator. e4od are electronic. no vacuum shift modulator
Should the modulator valve have transmission fluid in it?
If a vacuum modulator has fluid in the vacuum port, it has failed and should be replaced.
