I doesn't have enough, so when it falls it doesn't enough strength to make it break.
Answer:Because of its shape. The cube is strong but remove 2 sides and any force will knock it down. Same as a rectangle. But a circle has a perfect arch. The Romans found out that an arch will hold up more weight than any other shape. An arch is only a small portion of a circle and can withstand more weight or impact than any other shape. Water dams are shaped in an arch because the more pressure exerted upon it, the stronger it is. Its also why the forehead is arched. Its the hardest bone to break.there is no electricity running thru the wires yet
Is the bulb burned out?
A light bulb is designed to take electrical energy and radiate it as electromagnetic energy.It would be nice of all of that energy came out in the form of light, but that has never been accomplished yet. An incandescent light bulb ... the original kind ... radiates much more heatenergy than light energy. In other words, an incandescent light bulb works much more efficientlyas a heater than it does as a source of light.
None. A crew chief does the write-up of the fault. It is up to a mechanic to argue about why the bulb should not be replaced yet.
Question is not clear; however, if you were to install a 120watt bulb into 90 watt rated socket then it may work for a while for some. yet, even if it works then after a while will start burning quite often and the fixtures itself will be damaged permanently
Probably because he/she isn't ready to verbalize his/her feelings yet. Thomas Edison, the inventor of the light bulb, didn't speak until he was about three years of age.
I haven't done this on my Blazer yet but my manual says to reach up behind the bumper to the light socket, twist it and it will come out of the housing with the bulb so you can change it.
Are we talking about long fluorescent "tubes"?The socket may be bad, or the tube is not seated correctly in it's socket.Some fixtures use a socket that the tubes "twist" into.Twist the tube slightly in either direction until it seems "seated".
The depletion layer is thin yet. But if we continue using CFC, it will be more.
the Beastie Boys haven't broken up yet. but in light of Adam Yauch (MCA) it will most likely happen
I just replaced a blown third brake light bulb today. ... I have about 60k on my M and havent yet had to change the brake light---so if it only has to be done once in the ... If memory serves, the Concorde's is in the rear window. ... Well I decided to mod my 2004 300Mspecial Third Brake lights, not with a bulb ...
Replace bulbs, check operation of door switches. Check position of dome light switch. Make sure light bulb contacts are clean.