The first thing to check is what is the pressure at idle with the engine warm. You will need to instal a manual gauge. If it is above 15 psi, it is an electrical/sensor issue. If it is below 15, it is an internal engine issue.
The abs computer detects a malfunction and sets a code.
It will depend on the trouble codes. If they are circuit codes, you have a wiring problem. If they are other codes you could have a vacuum leak, stuck egr valve, or engine malfunction.
The wate pump is timing belt driven, and the weep hole is in that area.
If only the odometer is going blank, the cluster assembly is failing.
For the year 2010, they have five remaining cars and vehicles available. The cars with new editions coming out are the Chryser 300, PT cruiser, sebring, sebring convertible, and town & country.
If only the red brake light is coming on, the parking brake is on or the brake fluid is low. If the yellow abs light is also on, the abs computer has detected a malfunction and set a code.
Possible failed valve cover gasket.Possible failed valve cover gasket.
Passenger side near the water inlet (has three wires coming out). It's attached by one phillips head screw located underneath the sensor. Use a stubby screwdriver if you have one.
When the car is coming to a stop, it is decelerating--or it has negative acceleration.
Depends on where it is coming from. If it seems outside of the vehicle, it could be a hub bearing.
those extra wires are most likely for subs
About two hours depending on where specifically you are coming from and going to in those cities.