Want this question answered?
Only the ankle
Socket 478 was the only widespread name for this processor socket.
You can do without harm though it will only be 1/100th the brightness as it will only draw 1/100th the intended power, if you put a 24V bulb in a 240V socket it will burn out immediately as it would draw 100 times it's intended power.power = voltage squared / resistance
The microprocessor is installed into the CPU socket on the motherboard. A CPU socket can only fit a certain range of microprocessors.
A ball and socket joint is a joint that can swivel in many directions. This is in comparison to a joint that can only go back and forth. The ball and socket joit allows your wrist to be able to bend in all different directions.
The ohmmeter is usually used to measure the resistance of a given wire only.
land socket can only be used on land..... pin socket cannot be used in pagg.... agge tuhada raakha ae rabb
3.0 GHz Pentium 4s were manufactured for both Socket 478 and LGA775.
This question may be asking if it is safe to plug things into mains wall sockets if they have been left switched on with nothing plugged-in, and if it is safer to plug things in only after the sockets have been switched off? If, and only if, that is the meaning of this question, the answer is probably: It should not be dangerous to plug something into a switched-on socket but it is always a good idea - and safer - to switch off any socket before you plug anything into it. +++ The hazard is not in the plugging-in, but may arise from the appliance itself, if it starts unexpectedly.
Only use 110-120 volt appliances on a 110 volt socket.
Only as dangerous as their humans.
A single gang wall socket has only one outlet, so you can plug just one appliance into it.