answersLogoWhite

0


Best Answer

The Sebring is a Chrysler product. Replace the crankshaft position sensor before beginning any diagnosis.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would a 1998 Chrysler Sebring 2.5 v6 not have any spark at plugs?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would your 96 Chrysler sebring convertible stumble after you have changed the plugs and wires and cap?

you have 2of the plug wires on the wrong plugs or distributor cap


Why would oil be coming out of the block area where you add oil and the spark plugs are on a 1997 Chrysler Sebring?

Possible failed valve cover gasket.Possible failed valve cover gasket.


What would cause bad gas mileage in a 2005 Chrysler Sebring 2.7?

Sensor failure, would have check engine light on. Excessive idle time. Aggressive driving. Poor maintenance, spark plugs, air filter, etc. Low tire pressure.


Why would a 1997 Chrysler LHS be getting oil in three of the plugs?

The spark plug tubes need replaced.


Why would 1997 Chrysler LHS have oil in spark plugs?

Possible bad valve seals. I have had this problem with my 1999 and that is what I was told.


Why would 1997 Chrysler HS get oil in the spark plugs?

Worn down piston rings will allow the oil to seep up into top chamber where the spark plugs are. Otherwise, you just have too much oil in your crankcase.


Would the steering column out of a 2000 Chrysler cirrus interchange with a 2002 Chrysler Sebring?

No


Why would there be no spark or no fuel getting to engine on 1997 Chrysler sebring?

Possibly the crank sensor or the coil pack is dead. But with a dead crank sensor you also get no spark, no crank. No crank equals no fuel delivery.


Where can you find the engine diagram for a 2.7 liter Chrysler Sebring?

The best place to find an engine diagram for a Chrysler Sebring would be in the owner's manual. If you do not have your, contact Chrysler or check your library.


What torque setting would you use when tightening spark plugs on a 1989 new yorker?

In the "Chrysler Full-Size Models 1988-93 Automotive Repair Manual" says "Torque Specifications Ft-lbs Spark Plugs to set at "26"


Why would your spark plugs be loose?

the engine is constantly vibrating and it dislodges the spark plugs


What does it cost to replace a carburetor on a 2004 Chrysler Sebring?

It would be very expensive considering that car doesn't have a carburetor.