0
Yes. If you are referring to a "tow behind" or a light weight trailer model.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
1991 Nissan 240SX transmission removal?
take out the halfshafts pull the motor and unbolt the tranny
Where is the fuse for instrument panel in 1991 Nissan Stanza?
It is right down to the left of the steering wheel. you have to pull it off and then there are the fuses.
How can I kill and remove a tree stump and roots?
Most tree service companies have "stump grinders " that work very well on large stumps. There are also available chemical treatments which act much more slowly and also bio agents for the environmentally concerned.
How do you disable the traction control on a 1991 Nissan Fair-lady?
I don't think you can its built in with the abs....If your that serious you could pull the chip lol
How to remove a tree stump?
Depending on where you are you could use explosives since they make some specifically for getting rid of stumps Maybe the most ecological way is to make holes of 2 cm with a drill, then fill them with breed of Pleurotus ostreatus, oyster mushroom, wich will take care of the fibres and give you edible mushrooms.
1991 Nissan Pickupanyone know where you can find a wiring schematicdiagram for replacing the dash lights or just know the procedure for replacing the bulbs?
Pull the instrument panal, the bulbs should be obvious, small bases that quarter turn and pull out. Bulbs pull out of bases.
What is a grinder on a sailing boat?
A grinder is a person whose job on a boat is to use the winches to pull in, let out, haul up or bring down sails. It is the most physically demanding job on a yacht.
How do you remove key on crank stump end?
To remove your key on a crank stump end, try twisting it in successive clockwise and anticlockwise fashion while pulling it off.To remove your key on a crank stump end, simply twist it in successive clockwise and anticlockwise fashion while attempting to pull it off at the same time.
How do you change a clutch in a 1995 Nissan Altima?
pull out the transmission
How do you remove a shift knob on a Nissan Maxima?
twist then pull
Where is the oxygen sensor located in a 1991 Nissan Stanza?
it should be located in the exhaust , just past where it comes from the engine When you pull the engine up, look for where your manifold is. Go down to the bottom of it and it's right there, across from the radiator.
What are the steps of Unbilical Cord care?
It is important to keep the stump of the umbilical cord clean and dry. If the stump appears dirty it should be washed with plain water. After cleaning, place a clean cloth around the stump and fan it dry with a piece of paper. Fold the front of the baby's diaper down to expose the stump of the cord to the air. This will help the cord dry out naturally. Give the baby sponge baths until the cord does fall off. Do not pull the stump off even if it is hanging by just a thread or two. It is best to let it fall of naturally.
