It may run but the best course of action is to have it checked out right away. If the cam sensor is bad, the engine could be damaged beyond repair.
Either a wiring or a computer problem are possibilities.
P1362 code indicates a faulty top dead center sensor. It could be the sensor or a distributor problem. There is also the off chance that it is related to the timing belt.
P1391 - intermittent loss of cam or crank. Typically indicates a problem with either the crankshaft, or camshaft position sensor. The first thing I'd do? Replace the cam sensor in the distributor, the most likely cause that hasn't been eliminated yet. After that it comes down to chasing wires. Generally when you see this code it's a cam senor fault though.
There is no camshaft sensor on the engine. Your reading a generic code.
Camshaft sensor interrupter will send that code.
Code 54 is the Camshaft Sensor Circuit
Code 11 means no camshaft position sensor signal detected during engine crankingFix : Replace the camshaft sensor
Camshaft position sensor performance
That is the Camshaft Position sensor circuit
Camshaft Position Sensor A Circuit
Camshaft sensor circuit low.
If the same code resets, then you have a wiring problem.