0
You replaced your starter on 1992 Lincoln town car but it still wont crank could it be fuelpump?
Wiki User
∙ 14y ago
It could be the fuel pump, fuel filter, alternator, or the relay switch.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
I replaced the starter on a 2000 windstar with a 3.8L engine now the car won't start?
Does it turn over? Could be a bad starter solenoid Could be a bad starter Check wiring
Your starter keeps shorting out no wires are touching and kills the battery when trying to start What could be the reason for the starter shorting or grounding out?
If you have just replaced this starter then you probably have it hooked up incorrectly. If it is still the same old starter, then it has shorted out inside and needs to be replaced.
What would cause a car to whine and crank when trying to start it after 8 or so idle hours you have replaced the starter it is a Chevy s10 2001?
Did you follow the starter alignment instructions when you replaced the starter? Are you getting oil on the Bendix? That could cause the starter gear to engage slowly. It is possible that the replacment starter has a problem. Also, if the previous starter had the same problem it could have damaged the gear on the flex plate.
Your 1998 Bonneville will not start have replaced the battery the starter was replaced last year do you have any ideal what it may be?
COULD BE THE CRANK POSITION SENSOR
When I replaced a fuel pump in my 97 blazer it still won't start What could be the problem?
Dead starter?
92 Chevy 2500 you have replaced the starter when you turn the key the starter wont engage?
This could be a bad ignition switch, ignition relay, or ignition fuse.
Where is the solenoid located under the hood of a 1993 Chrysler Lebaron as it will not start we have replaced the battery and starter and could it need a new solenoid and where is that located?
may be on top of the starter and replaced with same. Follow the + battery cable it will connect to the solenoid
1993 E350 and you have replaced the starter solenoid the starter and the battery and the starter will not disengage after starting What could cause this?
Most commonly, it's the starter or the starter was wired wrong when it was installed. More rarely, it can also be the keyswitch or even a bad gear on the flex-plate.
What could be wrong if you have to start a 96 Pontiac Sunfire by putting a screw driver on the starter?
The starter solenoid, or ignition switch is bad, and either one needs to be replaced.
After you turn your 1981 mford econoline van on its like the starter wil not disengaged but you have had that fixed What could it be?
That wouldn't be your starter, it would be your clutch, get it replaced before it burns out or becomes stuck
What could be wrong if after installing a new battery and alternator truck still wont start or run?
It could be the starter in it. It may be weak or need replaced.
You replaced your battery and starter It still won't start It may be a fuse but all the fuses in the fuse box are good Where would a bad fuse be or could it be something else?
it could be that ignition switch or wires to it. wires to the starter.
