0
Your 1999 dodge ram van would not start It would fire but stall right away fuel pressure is good spark is good timing is good you replaced the tps map sensor idle control solenoidand computer?
Wiki User
∙ 15y ago
You should by a new computer. - Hold the gas petal in for about five minutes, just enough to keep it running, don't need to race the engine. If you slowly let it off, can you get it to idle then? May be a bad battery won't hold a reserve charge anymore, but still provides cranking amps to start it.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you fix internal control module in Dodge Neon?
The computer needs replaced.
Does a knock sensor have to be replaced?
Yes, it helps the engine control computer monitor and adjust the timing
Can a manual climate control unit be replaced with a digital climate control unit on a 99 corvette?
No the climate control is tied into the electronic control system of the car which is controled by the computer. The climate control can also be used to view or display fault codes from the computer...............
Can you just replace the transmission control module on a 1999 dodge ram?
The transmission is controlled by the engine computer. It can be replaced.
What is the part that shifts the transmission in and out overdrive on dodge 1500 ram 2007?
The engine computer uses the solenoid pack in the transmission to change which clutches get hydraulic pressure to control what gear is applied.The engine computer uses the solenoid pack in the transmission to change which clutches get hydraulic pressure to control what gear is applied.
89Camaro 305TBI replaced with a 350 crate motor carburated and trying to eliminate the computer Can you use your stock oil pressure gauge without the computer?
Yes. While the computer does monitor the oil pressure, since you eliminated the TBI in favore of the carb, the computer couldn't use the signals from the sensors to adjust the engine. Esentialy, the computer has no control over the functions of the carb hence the oil giage doesn't need the computer to function. It is attached to the engine through mechanical means(hose) or through direct connection from the gage to the sensor(rheostaticaly)
What is the icp sensor on a 2003 ford F250 super duty?
ICP= injection control pressure, it senses the high pressure oil and reports it to the computer to determine fuel control. It is located on the back center of the valley of the engine on the high pressure pump cover.
How do you reset the computer on a 1997 buick park avenue after a battery failure The abs check tire pressure and traction lights are coming on for no reason?
The computer resets itself. as for the ABS-Traction control-Tire Pressure... the ABS sensors on the wheels get information for your ABS, traction control and your tire pressure monitoring system, if the ABS has a problem, it disables itself along with the traction control and the tire monitor. You have a problem with your ABS system..get it checked out
How do you Check fuel pressure oo Toyota Echo?
How would I wire an EFIF control box to the computer to control the fuel mixture, so my hydrogen system works better
What is meant by logistics replaced in a car mean?
It means someone replaced the "computer" or electrical control unit. Its called something different from brand to brand but it controls the air:fuel ratio and many other things depending on the manufacturer.
Why does your 84 z die when accelerating Ignition coil has been replaced fuel pressure is good Is there a sensor doing this?
You have an ignition Control Module that you can check that controls ignition timing Throttle Position Sensor that tells the computer where the throttle is so it can regulate and give the correct air fuel ratio.
How do you control a computer shop?
you use remote control to control your computer shop
