Phone EROM is damaged, you can reset it by shorting the internal battery or upgrading its EROM by connecting it pressing 2+5 keys. by setool
That very well may be for the hazard switch. Try it and see if the lights blink when the button is depressed.
you do <button> and write whatever you want after no spaces.Ex:<button>Princess thats to make buttons to make them flash you do <blink> Ex: <blink>Princess
loose bulbs
This is the procedure for resetting the tsc light on the 99 Acura RL which should be the same. Set the parking brakes,push and hold the tcs switch (button) turn on ignition switch hold for 4 to6 seconds let go of tcs switch (button) should blink twice push button again light should go out,turn off ignition,then recheck for codes. Repeat if necessary.
The button on your dashboard
Get in the car and locate the trip odometer reset button. Turn the switch on. Make sure it is in the trip1 or T1 position. If not depress the button to change from t2 to t1. Now turn the switch back off and depress the odometer button and turn the key to position 2. When the service light starts to blink release the button and turn the switch off. When you start the car the light should be out. It may take a couples tries to get your timing right in the press release and key functions
300 to 400 milliseconds
With key on and stereo off hold both the clock and audio button clock reading will blink use up and down arrows to change hour then left and right to switch to minutes up and down to set press clock button again and done
There is a reset button in the fuse box under the hood on the drivers side. Open fuse box and look for the "reset" button. Turn ignition switch on, hold button in for approx. 10 seconds. If change oil light reset was successful, the oil change light will blink for a few seconds.
Hold the src/off button in the top left corner on the faceplate for 2 seconds. The time will blink on hours adjust it by the up and down buttons then to switch to minutes press the left button then adjust the minutes by the up or down button. After you get the desired time press source again and your time is set.
Faulty head light switch.
hold the button with the x on it until it starts to blink and its on.