'95 Buick power steering

Answer 1

3.8L Engine See Figure 9

Fig. 9: Power Steering pump mounting-3.8L engine

# Disconnect the negative battery cable. # Remove the coolant recovery reservoir and bracket. # Unfasten the ECM retaining nuts, then remove the cover. # Remove the serpentine belt from the pulleys by loosening the automatic belt tensioner as outlined in Routine Maintenance of this repair guide. # Disconnect the inlet and outlet hoses from the pump. # Unfasten the pump mounting bolts, then remove the pump and reservoir. # Using a suitable prybar, remove the retaining clips from the reservoir, then separate the reservoir from the pump. # Remove the pump pulley using a power steering pump pulley removing tool J-25034-B or equivalent. To install: # Install the reservoir to the pump with a new O-ring seal and install the retaining clip. Make sure the tabs are fully engaged on the pump. # Install the pulley to the power steering pump. # Install the pump and retaining bolts. Tighten the retaining bolts to 25 ft. lbs. (34 Nm). # Connect the inlet and outlet hoses to the pump. # Install the serpentine drive belt. # Install the ECM cover and secure with the retaining nuts. # Connect the negative battery cable. # Fill and bleed the power steering system as outlined later in this information. # Allow the engine to warm up, road test the vehicle and recheck the fluid level. # Check the system for leaks, road test and recheck the fluid level.