Remove wheel. Use a big C clamp to push against the outboard pad a bit to retract the caliper piston a little. Remove the two caliper bolts (1/2 inch head, top and bottom, on the inboard side. Pull the caliper off, remove the pads and tie it up out of the way. Leave the brake line hose connected. Check the master cylinder reservoir for enough capacity to force some brake fluid back up into it. If it's full, remove some. Replace the cap. Use the C clamp to push the piston all the way down until it bottoms out in its bore. You can have the rotor resurfaced or replace it, but if it looks in good condition, this is not essential. Put new pads in the caliper. Use some caliper grease on the back of the pads to prevent squeaking. Also put caliper grease on the inside of the rubber boots on the back that cover the ends of the bushings the caliper bolts go through. You want grease on the outside of the bushings, between them and the caliper body, so that the caliper can move inboard and outboard to center itself over the rotor and the pads wear evenly. Reassemble. Pump brakes before starting on a test drive.
Remove wheel Re-install 2 lug nuts to hold rotor in place Remove 2 caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully depress piston into caliper body Replace inner and outer pads Re-install caliper Depress brake pedal to set pads against rotor PRIOR TO MOVING VEHICLE
2001 Buick need to change the front brakes, I want to make sure there are no sensors or anything before removing them.
This is how you do it. First you have to say that wikianswers sucks, then you have to say that you want to kill your mother, then you just have to kill more people on earth.
Your hands, your hands
On my 1990 Buick Regal, I need an 18mm wrench , a 10mm wrench, screwdriver, jack, and a can of brake cleaner
What are the brake rotors minimum thickness on a 1997 Buick Century? Thanking you in advance.
The fuel filter for a 1999 Buick century is located on the drivers side frame in front of the fuel tank. It is an inline type and is easy to change.
I just paid $400+ tax on mine from front to back... Thats with labor at Mineke...
The front door speakers in a 2003 buick century are 5 1/4 inches.
How do you replace the front turn signal bulb located on a 2001 Buick Century?"
How do you change front brake hose on a 1997 lincoln
how to change front brake pads on a 2003 neon
The most likely problem is warped rotors. Have rotors turned or replaced. Replace front brake pads.