No, active transducers require a power source for operation.
An example of a passive transducer is differential transformers. The reason why is because passive transducers require an external power supply to operate.
A single element transducer is focused only by the manufacturer, Source is edelmans new "spi" physics workbook 2010......
Mithocondria
Operation Source happened on 1943-09-20.
An outside source of energy is required for systems that do not produce their own energy, such as electronic devices, vehicles, and buildings. This energy is needed to power the functioning of these systems and to perform the tasks they are designed for.
any transducer is measuring something it takes a bit of something to make the transducer work which loads the device under test as you put more power to an audio transducer it most move further and vibrate slower and as such loads the device and lowers the frequency if you are measuring temperature the measured device must also heat the thermometer which is a load on the heat source
To create a device that projects a sonic wave, you can use a transducer, such as a piezoelectric speaker or ultrasonic transducer, which converts electrical signals into sound waves. Connect the transducer to an audio source or a signal generator to produce the desired frequency. Encase the transducer in a suitable housing to direct the sound waves effectively. Ensure proper power supply and circuitry to amplify the signal for sufficient projection range.
is active...and bilateral
The energy source used by the calcium pump during its normal operation is adenosine triphosphate (ATP). This ATP is utilized to power the pump's active transport mechanism, which moves calcium ions against their concentration gradient across the cell membrane or within cellular compartments.
An active device is a device that takes input energy to operate. The only energy a diode uses is from the signal applied to it (it has one input, one output, and no other terminals), so it is a passive device. To be an active device, a separate power source must be applied to it - such as the case for operation amplifiers, for example.
The active ingredient in synthroid - Levothyroxine Source: rx2040. com
When it is required to increase the gain of a differential amplifier for that we have to increase the collector resistance to a large value which is difficult and also require larger chip area ,so instead we replace it by a constant current source that is a current mirror which is called an active load.