0
Behind the dash is the HVAC housing. The blend doors are in the very center of the box. The dash and HVAC will need removed to access.
Behind the dash is the HVAC housing. The blend doors are in the very center of the box. The dash and HVAC will need removed to access.
Wiki User
∙ 11y ago
Wiki User
∙ 11y agoBehind the dash is the HVAC housing. The blend doors are in the very center of the box. The dash and HVAC will need removed to access.
Add your answer:
Earn +20 pts
Why does AC of a 1999 Buick century with dual controls blow warm on drivers side and cold on passenger side?
Bad "blend door" actuator or stuck blend door on the driver's side.
What causes bad blend door operation on a 95 aurora cold on passenger side but warm on driver side?
Cannot speak specifically to a Oldsmobile but, on a Dodge product of same vintage it would be low freon. Either that, or it could be a bad control head, or a bad blend door actuator.
Why no heat coming out driver side vents but out passenger side only?
your blend door which cost about $1000-1500
Where is the blend door for 2004 Oldsmobile alero?
You can find the 2004 Oldsmobile blend door behind the passenger side kick plate. Remove the kick plate to access the blending door.
How do you open the passenger side sliding door on a 1996 dodge caravan?
Use the handle!
Where is the temp control acutator for blend door on 1999 silverado 2500?
if driver side not working it is on passenger side @ bottom of heater case. they also have one on drivers side right of gas pedal, recirc door is upper dash passenger side
Where the air blend door actuator passenger side on 2004 Chevy silverado?
It is under the dash on top of the HVAC module
Pontiac grand prix 1999 ac blows cold on passenger side and warm on drivers side.?
Temp blend door actuator malfunction.
When you turn your heater on in Jeep Cherokee you get cold air on driver side and hot air passenger side?
That sounds like a blend door problem.
Where is and how do I check Blend door on my dodge ram 1996?
The blend door actuator motor is located on the bottom of the plenum box on the passenger side towards the transmission tunnel. It is easy to remove and examine the motor to blend door connection. The blend door on the Ram is made of metal and seldom breaks. The problem is more likely the plastic interposer that spans between the metal drive motor connection the the metal axle. Check Ebay listings for HeaterTreater to find the Ram and a 100% solution and more diagnostic information.
How many blend door actuators is on a 2000 Pontiac Grand Prix?
If the car has a separate temp control for the passenger side and the driver side it would have two blend doors, otherwise it would only have one.
Is there more than one blend door actuator on Pontiac grand prix yr 2000?
yes one on the drivers side and one on passenger side
