0
back side of the brake pedal
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Why does the fuse blow when you push in on the brake peddle on your 1968 vw beetle?
Because there's a short somewhere in the system, and it's probably on the master cylinder. VW, for some reason, used a brake light switch that's activated by brake fluid pressure. The switch is under the car where it gets wet.
1968 volkswagen bus brake lights not working?
Check bulbs, fuse, brake light sensors.
Where is the fuse box on a 1968 Corvette?
The 1968 corvette fuse panel is under the drivers lower left side of the dash .
Why don't the wipers work on a 1968 corvette have a new wipermotor new engine wire harness and new switch when switch goes to on you here a click under dash?
ground issue on wiper motor housing
How do you change heater core in a 1968 corvette?
no
How much did a Corvette cost in 1968?
4,663.00 for the coupe.
What is the length of a 1968 Corvette?
182.1 inches is the overall length.
How do you remove light switch knob on 1968 camaro?
It's tight, but it just pulls off... With some effort.
What is the difference between a Corvette roadster and a Corvette stingray?
A roadster is a convertible. The Stingray was the 1969-1977 Corvette model. The 1968 was the same body style, but was not called Stingray.
1968 f 250 turn left signal will not blink when brake on?
most likely the rear brake light bulb has a broken wire which is shorting the circuit. change the bulb and it's fixed.
What are the timing specs on a 1968 Corvette?
Factory stock ignition timing for the Corvette 327 ci 350 HP is 4 degrees BTDC.
What cars where popular in 1968?
68 charger 68 mustang 68 corvette
