0
Best Answer
Its becaue the slave cylinder is has a leak, and pressure is lost when you press on the brakes.
Wiki User
∙ 14y agoThis answer is:
Add your answer:
Earn +20 ptsQ: 1988 Honda Accord brake pedal too low?
Write your answer...
Submit
Still have questions?
Related questions
How type of brake fluid 1988 Honda accord?
DOT3 from an unopened can.
What is the button next to the emergency brake in a 1988 Honda Accord do?
Possibly power mirror switch.
Why would a 1988 Honda Accord sputter and lunge at idle when your foot is on the brake?
Carburetor needs rebuilding, most likely.
How do you replace the right rear brake light on a 1988 Honda Accord LX?
either acces it through the trunk or screws on the outside...
What brand engine will fit in your 1988 Honda accord?
Honda.
What does it mean when your 1988 Honda Civic brake light is stuck on?
Probably bad or mis-adjusted stop light switch Should be located on top area of brake pedal
Is a 1988 Honda Accord fast?
Absolutley not.
How do you check the transmission fluid in a 1988 Honda Accord dx found the plug but how do you read it?
how do i check the transmission fluid on a 1988 Honda accord, it is a automated
Can you use a transmission from a 1990 or 1993 Honda Accord for your 1988 Honda Accord?
no u cannot do that bolt pattern is different
What is the battery size for a 1988 Honda Accord LX?
The battery size for a 1988 Honda Accord LX is a size 25. The battery can be purchased at any auto parts store.
Where do you add Brake fluid to a 1988 Honda Accord?
At the master cylinder brake fluid reservoir located driver's side next to the firewall on top of the master cylinder. Use DOT 3 fluid.
What is the bolt pattern on a 1988 Honda accord lxi?
4x100
Copyright ©2024 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.