answersLogoWhite

0

# Battery connections loose or corroded # Battery discharged or faulty # Transmission not completely engaged in park or neutral # Broken,loose or disconnected wiring in the starting circuit # Starter motor pinion jammed # Starter solenoid faulty # Starter motor faulty # Ignition switch faulty or NSS neutral safety switch bad. If it's a manual transmission there is also a safety for the clutch. If it's an automatic, there is a shorting plug. In either case this switch may be bad also.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How much stock horse power does the 1989 ford bronco have?

stock 2.9 144 hp


Diagram of a 1989 Bronco II Fuse Box?

list of fuses for 1989 bronco 2


How much power does a 1989 ford bronco 2 have it has a 2.9 engine in it?

I believe that is rated at ( 140 horsepower ) from the factory


Will the auto trans from 1986 302 bronco work in a 1989 351 bronco?

it shold


Will a 1984 ford bronco back window fit a 1989 ford bronco?

yes


Can you take oil pan off 1989 bronco without removing the engine from the vehicle?

how to remove oil pan from 1989 bronco 2


What is the fuel pump wiring diagram for a 1989 ford bronco 11?

A wiring diagram of a 1989 Bronco 11 fuel pump can be purchased from most auto parts stores. It can also be found in do-it-yourself repair books for a 1989 Bronco 11.


Where do you put power steering fluid in on a 1989 ford bronco?

Looking at the engine on the left side under the A/C compressor . That is the power steering pump. Uses ATF.


What rear end is in the 1989 bronco?

8.8


The fuel pump in your 1989 ford bronco is not responding What should you do to fix this problem?

first check your fuses and fuel relays make your power to the pump. check the fuel reset swich. i good manual would be a good start..


What size engine is in the 1989 Ford Bronco II?

A 1989 Ford Bronco II has a ( 2.9 liter / 177 cubic inch V6 engine )


1989 ford bronco the key turns to the start position but will not start. the accessories turn on but no starter. I can start it by using a screwdriver on the silioned.?

the ground wire running from the starter solinoid to the starter sounds to be bad