yes
To remove the window in the rear hatch of a 1989 Ford Bronco, the weather stripping around the window will have to be pulled back or pushed down slightly. This can be accomplished with a straight screwdriver or a putty knife.
break it
It's about this wide and about yay so tall...
check any bronco group web site, membership is usually free and they have all the schematics for the back window wiring and more
In a 1988 Ford Bronco, the switch to roll down the back window is typically located on the driver's side door panel. It may be a toggle switch or a push-button switch, often positioned near the controls for the front windows. If the Bronco has power windows, there might also be a separate switch for the rear window on the rear door or center console, depending on the specific model configuration.
1989 Bronco11 back hatch door won,t open
If its the bronco XLT you'll have to take the tail gate paneling off the inside. The motor, gears, etc. for the rear window are located in there. I had the same problem with mine sometime back.
Try Wd 40 in the left and right guides
Kate and Allie - 1984 My Boyfriend's Back 6-21 was released on: USA: 15 May 1989
you have to take all the plastic trim off inside the rear around the window the window is bolted into place yes i know it sounds crazy but there little nuts tend bolts are molded into the rubber around the window and nuts on the inside so there you go
Look under the dash, in the center. It will be a black box with a white button. Just push the button back in.
i broke my speedometer and it says 85 and it started coming back around and broke and it was in 5th gear 2500 rpms