yes
1989 Bronco11 back hatch door won,t open
how to remove oil pan from 1989 bronco 2
To change the window regulator on a 1989 Bronco II, start by removing the door panel screws and carefully prying off the panel to access the interior components. Disconnect the electrical connector and any clips holding the window glass in place, then remove the glass from the regulator. Unbolt the old regulator from the door frame, then install the new regulator by reversing the steps: attach it, reinsert the window glass, and reconnect the electrical components before reassembling the door panel.
If the tailgate window of a 1989 Bronco won't go down, the issue could be due to a faulty power window switch, a broken window motor, or a problem with the wiring. Additionally, the window track may be obstructed or damaged. Checking the fuses can help eliminate electrical issues, and inspecting the motor and switch for damage can pinpoint the cause. If necessary, consulting a repair manual or a professional mechanic is advisable for more complex issues.
list of fuses for 1989 bronco 2
Turning the window crank in a counter clockwise direction, the window will go down, reverse direction to raise it. If you are speaking of the rear window the switch is on the a/c control panel. Down makes the window go down and up is up
check your tailgate switch on the dash mine went bad and after i replaced it it was like new
You will need to remove the inside door panel in your 1989 Ford Mustang. Remove the window retaining clips. The window will lift out. Reverse the process to install the new window.
It unscrews by turning counterclockwise. There is a small "flat" on the shaft to assist in removal.
Well you take out the tail light assem and remove the blown bulb
remove batt. cable from starter(its not wired to batt so has no power) remove 2 1/2 bolts remove starter