If its the bronco XLT you'll have to take the tail gate paneling off the inside. The motor, gears, etc. for the rear window are located in there. I had the same problem with mine sometime back.
Yes, you can manually roll up the window on a 1990 Ford Bronco if the power window mechanism is malfunctioning. You would need to access the window regulator assembly, typically by removing the door panel. Once exposed, you can either use a tool to turn the regulator manually or reattach any disconnected components to restore functionality. Always ensure safety and consult a repair manual if you're unfamiliar with the process.
yes
The Ford Bronco is categorized in one of five generations, with the 1986 model falling within the 3rd generation. The base curb weight of a 1986 Ford Bronco is approximately 4374 lbs.
you cannot manually roll up the window. I disconnected the harness and used 2 wires to jump power from the cargo light socket to the harness, one way is up the other is down by reversing them.
what is the question?
yes, you must remove the door panel and remove the window motor bolts enough to move the window freely, once you have it up you can put the window motor back in in order to hold it in place. it works if you get the teeth lined up trust me i just did it :)
The base curb weight of the 1986 Ford Bronco is 4,374 pounds. This is for the 4.9 liter North American version.
A 1986 Ford Bronco II would use R12 unless it has been converted
no.
yes you may have to inter change a few things but they will fit
To remove the window in the rear hatch of a 1989 Ford Bronco, the weather stripping around the window will have to be pulled back or pushed down slightly. This can be accomplished with a straight screwdriver or a putty knife.
Is there just a gear or a timing chain on a 1985 ford bronco 11 2.8 liter V 6.