you have to make sure that your engine is set at tdc (top dead center) then you have to put the rotor set at the number one spark plug wire,make sure you put the distributer in carefully and not to damage the shaft.
how the sequence of spark plugs goes on the engine of 1990 Toyota cressida
Pls let me know the cylinder head bolt tightening sequence for toyota cressida mx83
Are you sure of the engine size? Should be 7mge inline six cyl. 22r wasn't offered in a 1990 cressida.
Its under the intake manifold/plenum towards the rear of the engine
tail light fuse Toyota86 Cressida
Buy a kit at Wal-Mart or auto parts comes with instructions Probably will have to be converted from R-12 to R-134
No. The coil is the piece at the other end of the wire that comes out of the center of the distributor cap.
its under the distributor cap. its black and is held to the distributor with 4 Phillips screws. there are 2 studs for the control wires.
I had the same problem with my 1989 Toyota cressida and when I had it looked at they said it was because the temperature gauge kept getting stuck and when it got loose it would fly way up into the red line and then return to normal like yours, you should get it replaced so that your car would send out unnerssisary engeint coolent
A 1990 Toyota Corolla.
there is none
My Chilton Says 1990 -92 Idle IN Park At Operating Temp Should Be 750, in drive 700, i cant ever seem to make the rpm drop only 50rpms when putting in park, so mine is set to 800, and about 700 in drive