0
1 - 4 - 2 - 5 - 3 - 6
---------------------------------------------------------------------------
The engine cylinders / spark plug locations are numbered :
3 - 6
2 - 5
1 - 4
front
-----------------------------------------------------------------------------
The Coil Pack Towers are numbered :
coil---3---4
pack--2---6
plug---1---5
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where can you find a vacuum hose schematic for 1995 40L AWD aerostar?
It is located underneath the hood. You might have to clean it off with a rag to read it.
How many cm3 are in 40L?
40L = 40000cm3
Would a gasoline tank hold about 40ml or 40L?
On a car, 40 liters.
The person name that killed Aaliyah?
The pilot-operator of the Cessna 40l which fatally crashed.
Is there an access door for a fuel pump on a 96 4 door 4x4 40L explorer?
No door. You have to drop the tank.
Where is the fuel filter on a 1995 Jeep Wrangler 40L?
Look under vehicle foolow the fuel line from the tank
Where is the fuel filter on a 1997 Jeep Wrangler 40L?
It's part of the fuel pump assembly located inside the gas tank.
Engine removal procedure98 explorer 40L V6?
Get a Haynes or Chiltons manual from an auto parts store and don't forget to label everything.
What is the oil to petrol mix for a dt15 suzuki outboard?
My mechanic says 100:1 I have done this for 40l last season without a problem
Can you fit a 50 mustang engine in a 1993 ford explorer xlt 2x4 40l v6?
i would deffinatly say yes since some of the year models came with a 5.0 stock.
Where is the oil pressure switch located on a 93 Ford Ranger 40L V6?
the oil pressure switch is located on the left side below the power steering pump. it is about 1.5 - 2 inches and about 2.5 inches long
Where is the egr valve located on a 1993 Ford Aerostar 40l engine?
I have a 96 4.0. I found the egr valve under the hood, near the battery. It has a small pipe that connects to the exhaust pipe, and is bolted to the drivers side of the engine. It also has vacuum line attached and is either connected with a hose or is ported to the intake manifold. It's been a while since I've messed with it. Mine was not frozen, so I didn't replace it. Of course I'm still getting a trouble code p0401. I now suspect a vacuum leak that prevents the valve from opening properly. I still need to check that out. Good luck.
