Clean them off and try blue loctite on the threads...
follow your top radiator hose,its in the thermostat cover,two bolts hold it on.
Might want to pull off the inspection cover and see if the bolts that hold the torque converter are tight. Also check the condition of the flexplate.
Right on top of the valve cover.
You have to remove the black plastic cover that is in the center of the valve cover. 4 bolts the two you see and if you look at the black box part at the front of the valve cover you will see the other two bolts. Take all 4 bolts out, remove the black plastic cover and you will see the spark plug wires. Good You have to remove the black plastic cover that is in the center of the valve cover. 4 bolts the two you see and if you look at the black box part at the front of the valve cover you will see the other two bolts. Take all 4 bolts out, remove the black plastic cover and you will see the spark plug wires. Good
hondahookup.com has manuals
Three Allen head bolts or t-25 torx bolts. it should separate from the outer primary case. There will be an o-ring gasket behind that.
the fuel pump is in the truck behind the back seat, 4 bolts to remove the cover, its on the left side six bolts to go and pull straight up.
Just unbolt it and pull it out. Then replace the gasket and reinstall the bolts. If you have a V6 there is a cover that goes with it. On the 4 cyl. You might find it easier to remove the manifold cover.
The 1990 Ford Festiva 1.3 liter engine cylinder head bolt torque specification is 125 pounds. The cylinder head bolts should be torqued in 25 pound intervals.
The 1990 Blazer does not have a carburetor.
how do I remove a water pump on a 1990 4.5 liter cadillac engine
What are the valveadjustment's on a 1990 iroc camaro with a 5.7 liter 350 motor