EGR Systems
Ford Tempo
Ford Explorer XLT
Ford F-350

Where is the EGR valve located on a 1990 Ford Tempo 2.3 liter atoumatic transmission?

192021

Top Answer
User Avatar
Wiki User
2004-12-02 07:12:35
2004-12-02 07:12:35

Right on top of the valve cover.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The transmission fluid is located in the transmission.

User Avatar

located in the transmission case where the speedo cable connects

User Avatar

The 1990 Ford Tempo base sedan has a curb weight of 2,587 pounds. The base sedan came with a 2.3 liter, 4-cylinder engine, and had a 3-speed automatic transmission.

User Avatar

It is located on the side of the transmission.

User Avatar

If you have the 3.3 liter, pop the hood and it will be located on the transmission on the passengers side. Look for a little pigtail running from the transmission. There it is.

User Avatar

The 2007 Jeep Grand Cherokee transmission control module is located on the back of the transmission. The transmission control module will be in the upper left-hand corner of the transmission.

User Avatar

You can fit the remanufactured 18 liter Ford engine in the 1989 Tempo. You can also choose the 3.0 liter SHO engine that was found in the Escort at about the same time.รŠ

User Avatar

The starter solenoid is on the starter. The transmission solenoids are in the solenoid pack on the front of the transmission.

User Avatar

That would be the 4L60e transmission.

User Avatar

It is inside the frame rail on driver side, were the transmission cross member is.

User Avatar

In the transmission tail section same place the speedo gear is.

User Avatar

yes it does it mite be the postioning senser located above your transmission housing

User Avatar

The engine computer on the firewall also handles the transmission.

User Avatar

It is located in the bottom of the battery tray in the engine compartment. RF/MPLS

User Avatar

How would i repair a 1993 ford explorer 4.0 liter A4LD Transmission?

User Avatar

If the S-10 was equiped with a 4.3 liter engine the transmission will probably fit the 350. The transmission used with the 2.8 liter engine WILL NOT fit the 350 engine.

User Avatar

The vehicle speed sensor (vss) should be located on the driver side on the front of the transmission close to the axle. Their should be an ear protruding out from the transmission, and the sensor will be to the right of it.

User Avatar

yes they are the same transmission, does not matter if the engine is a d15 1.5 liter or a d16 1.6 liter

User Avatar

If the engine in the Ford Tempo is a 2.3 liter engine, the wire order is 1-3-4-2. If the engine is a 3.0 liter engine, the wire order is 1-4-2-5-3-6.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.