answersLogoWhite

0

bad wire it may be grounding out

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you bypass the resistor in the key ignition on a 1991 firebird?

buy a DFVATS Bypass Module from www.bakerelectronix.com


Why would a 1991 Pontiac Firebird not start after you replaced the steering column?

Because when you change the ignition in a firebird you have to use the same key and key lock that was on the original column. If you don


Where is the fuse for the third brake light on a 1991 Pontiac Firebird?

It is listed in the 1991 Pontiac Firebird Operations Manual


Just bought a 1991 firebird only came with ignition keys is there a way to manually release the rear hatch?

no there is a different key 4 that and the key is also used for the doors as well


Gas milage Pontiac 1991 Firebird?

I calc'ed my '91 V8 Formula Firebird to be about 18 mpg.


Does 91 Pontiac firebird have 3rd gen?

A firebird can't "have" third gen. It either is or is not a third generation firebird, and Yes, a 1991 is a third generation.


Will a 1989 firebird transmission mount up in a 1991 firebird?

If they are both Chevy V8 cars it will bolt up.


Will parts off of a 1989 Pontiac firebird work on a 1991 Pontiac firebird?

What parts??? Body, engine, suspension???


Where is the 1991 firebird convenience center located?

According to two mechanics at two different dealers-There is no Concenience Center on this Firebird.


Where is the fuel pump inertia switch on a 1991 firebird?

None


Wiring diagram for 1991 firebird?

A wiring diagram, for a 1991 Pontiac Firebird, can be obtained from most General Motors dealerships. The wiring diagram can also be found at most auto-parts stores.


How do you reset the security light on a 91 Pontiac Firebird?

To reset the security light on a 1991 Pontiac Firebird, first, ensure that the vehicle is in the "Run" position without starting the engine. Then, turn the ignition off and back to "Run" three times in quick succession. After the third cycle, leave the ignition in "Run" for a few seconds, then turn it off again. This should reset the security system and turn off the security light.