answersLogoWhite

0


Best Answer

Check fuses and relays. If you have power coming from the ignition switch but not getting to the starter there might be a bad fuse or relay or wire. Also make sure you have the wiring correct to the starter since you just replaced it.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1992 Mighty Max won't turn over Replaced Ignition switch and starter and still doesn't turn over?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1991 gmc van that will not start the battery is fine and the fuel pump turns on with the key and the battery but it just doesnt even engage the starter could the starter or ignition be out?

Most often it is the starter and not the ignition.


I have to turn the ignition key several times before it will start. I doesnt do it every time. The battery is ok. Any ideas?

Ignition switch going bad, corroded or loose battery cables, starter relay or starter going bad.


How do you start a 1986 Yamaha pw 50 if it doesnt have a kick starter?

turn ignition system and fuel system on then put in 2nd gear and push


On a 1994 Isuzu Amigo SOMETIMES when i turn my key to start it doesnt do anything i have to keep turning key off and keep trying and finally it will start...What causes that?

Either the starter, starter relay or ignition switch are failing.


Why will a 91 Lincoln Town Car start with a screwdriver touching the solenoid but not with the key manually?

Not to bash on the last answer, but, the starter solenoid probably isn't at fault here. If it will start with the screwdriver then the starter solenoid is functioning. It either does or it doesnt. The answer lies in circuitry back from the solenoid to the ignition switch. You could have a bad ignition switch or neutral/safety switch.AnswerDefective starter solenoid.


Why doesnt starter engage always with new starter and flywheel?

Some vehicles require "shims" to be installed when a starter is replaced so the Bendix drive will engage the pressure plate teeth. If the starter is too far away from the teeth on the pressure plate, the vehicle will fail to turn over.


Why is it that sometimes my 2002 Trans am starts right up and other times it doesnt crank or start and the battery is good.?

you can try to short the starter motor . take a screw driver and bridge ffrom battery cable on starter to ignition wire on starter. if starter is good, engine will crank. if starter is bad , solenoid will click if no clicking, solenoid is bad


How about if it doesnt make any noise when you try to started but the batterie is find?

No noise when you try to start the vehicle usually indicates a dead battery, or a loose or disconnected cable/wire at the starter, solenoid (starter relay switch), or ignition switch.


Why wont your Suzuki vitara start the battery is new and works but the engine doesnt click or start what could be wrong?

"Dead" Starter CircuitsI'm not familiar with your vehicle, but...I suspect that the problem is an "open circuit" conditionin the circuit between your ignition switch and the starter solenoid, or possibly the starter solenoid itself.Something that is supposed to be in contact is disconnected, or possibly the contacts inside the ignition switch have failed and won't make contact.


What was Max's impression of himself in Freak the Mighty?

he doesnt talk


1992 Honda accord that wont turn over you think it might be the timing belt where is that located?

if it doesnt turn over at all the starter is bad if it turns over but doesnt fire it could be ignition or belt related check wit a qualified mechanic shop


How do you know the starter is bad in a Honda civic?

usually you can tell when your car doesnt turn or or doesnt turn over its because of your starter sometimes its not the starter it could be a low battery or corroded wires leading to the starter check that first;