answersLogoWhite

0

1993 Chevy 1500 chugs when push gas down?

Updated: 8/17/2019
User Avatar

Wiki User

14y ago

Best Answer

sounds like it is not getting enough fuel, replce fuel filter and if nessary check fuel pump pressure.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1993 Chevy 1500 chugs when push gas down?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where are the oil hoses located on the 1993 Chevy 1500?

If you are talking about the engine oil cooler lines, Then they are just above the oil filter and run down the side of the engine to the radiator.


Where is the fuel filter on a 1993 Chevy 1500 pickup?

It is in the frame rail on driverside, back by the Transmission cross member. You will have to lay down under the truck, and look up into the frame.


How do you fold down mid-gate on 2003 avalanche LT 1500?

how do u fold down mid-gate on 2003 chevy avalanche LT 1500


What is the idle on a 1992 Chevy truck with a 350?

1500 at first until it kicks down to 850 rpm


What way does the thermostat go in on a 1994 Chevy silverado 1500 5-7L.?

The spring goes down in the engine


What causes a 1993 MX6 to idle up and down from about 1500-2800 rpm?

You could have a bad exhaust valve


What else holds the tank on an 89 Chevy 1500 besides the straps?

Nothing. It is just STUCK to the truck. Pry it down.


Where is the Ecm location on 1993 Chevy c1500?

Take the inside of the glove box out and look in and down to the right and you will see it.


92 Chevy 1500 pu dies while driving down the road and will restart after it dies each time?

clogged fuel filter


What side of thermostat goes upon a 1994 1500 series Chevy 6cyl pickup?

The spring on the thermostat goes down towards the engine.


How do you remove the tailgate from a 1993 Chevy Blazer What if the window is broken out and the tailgate wont go down?

take it to a transmission shop


Will 16 inch wheels fit on your 2006 Chevy 1500?

No front brake calipers are to big. If you must calipers can be machined down at a big cost.