take it to a transmission shop
If the outside handle of your 1992 S10 Blazer is broken, you can try accessing the tailgate through the rear window. Use a flathead screwdriver or a similar tool to pry open the window slightly, then reach inside to manually unlock the tailgate latch. Alternatively, you can remove the interior panel of the tailgate to access the latch mechanism directly and open it from the inside. If these methods are not feasible, consider using a professional locksmith or technician for assistance.
its locked while window is down.
how do remove the tailgate's window motor on a toyota 4runner 1997 ?
you have to roll the window down and opend it from the inside. You are not supposed to opend it with the window up because it could break.
The 1988 Chevrolet Blazer tailgate window motor might be bad and need to be replaced. The window motor fuse might be blown and needs to be replaced.
Had this happen on my Blazer the hose came disconnected in the tailgate and the washer fluid was emptying into the tailgate. You need to take the inside panel off to get at the hose to reconnect. Also dry your tailgate out. Needless to say I no longer use this option.
1992 chev blazer reartail gate window lock is broken ------------------------------------------------------------------------------------- On the 89, (83-94 S10/S15 Blazer) you turn the latch with key one direction and it opens the window. Then once the window is open, you can turn it the other direction and it opens the tailgate. On mine, the part with the "ears" started slipping. The window would still open easily with just the key. However, I was barely able to get the tailgate open using just the key. Replacement parts are available on the internet and E-Bay. You can remove the key part by removing the inside panel of the tailgate (must be open). Then 4 - 10mm bolts to hold on a cover. You may need to remove the rest of the latch mechanism (or at least push it out of the way). A slide-type clip holds the latch in place. Pry and slide the clip to the right (passenger side). The latch should come out and can be replaced. I'm trying a "repair" now. More notes later since I don't feel like trying to re-key a generic.
i used a hammer
You will need to remove the inside door panel of your Chevrolet Blazer. Remove the window retaining clips. Put the window back into the window track. Tighten the window retaining clips.
You will need to remove the inside door panel of your 1977 Chevrolet blazer. Remove the window crank linkage. Remove the window crank retaining bolts. Reverse the process to install the new window crank.
To replace the tailgate window on a 2000 Toyota 4Runner, first, ensure you have the correct replacement glass. Start by removing the interior trim panel of the tailgate to access the window mechanism. Disconnect the wiring harness and any clips holding the old glass in place, then carefully remove the broken window. Finally, install the new glass by reversing the process, ensuring it is properly aligned and secured before reattaching the trim panel.
After you pop the window either with your remote or the button on the dash you can use a very big screwdriver to open the gate. I found a replacement knob for my tailgate with keys at www.rockauto.com, they were very reasonably priced and quick and easy to change out.