If the outside handle of your 1992 S10 Blazer is broken, you can try accessing the tailgate through the rear window. Use a flathead screwdriver or a similar tool to pry open the window slightly, then reach inside to manually unlock the tailgate latch. Alternatively, you can remove the interior panel of the tailgate to access the latch mechanism directly and open it from the inside. If these methods are not feasible, consider using a professional locksmith or technician for assistance.
If the tailgate handle on your S10 Blazer is broken, you can try accessing the tailgate through the interior. Remove the interior panel near the tailgate to reach the latch mechanism directly. You can then manually pull the latch with a tool to open the tailgate. Alternatively, you might consider using a slim jim or other tools to unlock it from the outside, but be cautious to avoid damage.
First you need to remove the trim bezel around the handle on the outside of the tailgate. Then remove the three bolts on the inside of the tailgate,that hold the handle in place. Next remove the latching mechanism rods from the handle,and remove the handle from the tailgate.
To remove the tailgate lock on a 1989 S-10 Blazer, first remove the cover over the inside of the tailgate by removing the bolts on the side and on the handle. Pop the vinyl away from the tailgate. Then remove the bolts holding the lock on and remove the lock.
After you pop the window either with your remote or the button on the dash you can use a very big screwdriver to open the gate. I found a replacement knob for my tailgate with keys at www.rockauto.com, they were very reasonably priced and quick and easy to change out.
2001 nissan how do you remove the nissan emblem to access replace broken handle
Need to know inside or outside door handle.
The inside of the tailgate, that is the part that faces up when the tailgate is down will have a panel that is held on by screws, it will give you access to the inner workings. Usually it is a little 20 cent retainer that has broken and is available at any parts store.
Most often the cause is two broken clips inside the tail gate mechanism. By pushing upwards you can remove the plastic bezel around the tailgate handle; its just snapped into place. You should now be able to see the mechanism under the handle. There are two metal bars coming in from the sides of the tailgate. These operate the latches on either side of the tailgate. They are attached to the central tailgate handle mechanism by plastic clips. One is pink and one is green; colored to indicate whether they go on the right or the left. You can get these clips from a dealership for about 5 bucks a piece. Hope that helps.
To replace the tailgate handle on a 2007 Chevy Avalanche, first, open the tailgate and remove the screws holding the handle in place, typically located on the inside. Next, disconnect the linkage connected to the handle and gently pull the handle out. Install the new handle by reversing the process: insert it into place, reconnect the linkage, and secure it with the screws. Finally, test the new handle to ensure it functions properly before closing the tailgate.
To open the tailgate on a 1999 Chevy Tracker, locate the tailgate handle located between the rear lights. Pull the handle upward to unlock and release the tailgate. If the tailgate is stuck, ensure that the vehicle is in park and check for any obstructions or issues with the locking mechanism. If necessary, you may need to use a key to unlock the tailgate if it is locked.
Remove the long access panel from the inside of the tailgate.Unhook the two metal rods from the handle on the inside of the tailgate.Remove the two bolts from the door handle located on the inside of the tailgate.
Seperate valve for outside faucet turned off, broken valve stem inside of outside faucet or handle stripped at faucet.