outboard motor will start and idle, but dies out under load
mabe its your clutch activation sensor that isn't working it happend on 2 of my cars
There are a couple of reasons why a 1993 Mercury Villager is hard to shift. One reason could be a gear shift cable. Another reason could be low transmission fluid.
clutch switch is bad
First what motor is in the van? Than tell me what it does before it stalls or you put it in gear. There many different possiables that it could be.
These parts are probably not available new any more. You'll have to get them from a salvage yard.
I have run into this before on other makes of cars and it was the altenator. If you can get the car to a parts house like auto zone they can sometimes test them for you for free.
I assume you have a cable speedometer. If so, just follow the cable on the firewall in the engine compartment to the transmission. When you take the cable out there is a small gear in there. That's it.
Check your fuel pressure first then go from there.
check for vacuum leak or dirty fuel filter
your car stalls when u gear down because you geared down too much. your car stalls when u gear down because you geared down too much.
A 1993 What
UK Gear was created in 1993.
what causes a boat motor 40 hp to stall when it is put in gear
Try putting up the kickstand
it sounds like the neutral switch
There is no way to change gear ratios.
Kick stand switch??
Because its a Chevy corsica not a ford corsica!!!!!
Mine did this and I found out it was the timing belt that needed to be changed.
The diagnostic code PO735 on a Mercury Mountaineer indicates that the 5th gear has an incorrect gear ratio. This can be the result of a broken servo shaft.
specify "not go into drive" does that mean it stalls or?
your clutch is probably shot
check your fuel filter and also your spark plugs.
The 1973 model, 7.5 hp Mercury outboard, requires 6.8 oz. of gear oil.