si
http://www.corolland.com/corolla/1993-1997/1993.html
sounds like the cable broke usually on the transmission end
There is no cable.. its electronic
yes
there is not one it's electronic
A 1993 Jeep Grand Cherokee does not have a speedometer cable. The speedometer signal comes from a sensor on the transmission or transfer case.
To replace the speedometer cable in a 1998 Toyota Corolla, first, disconnect the negative battery terminal for safety. Remove the dashboard panel to access the speedometer, then detach the speedometer cable from the back of the speedometer by twisting it counterclockwise. Next, locate the other end of the cable at the transmission, disconnect it, and install the new cable by reversing the removal process, ensuring it is properly connected at both ends. Finally, reassemble the dashboard and reconnect the battery.
its electronic, there is no cable
Most likely speedometer cable
The speedometer in a 1988 Toyota Corolla is cable-driven. This means it uses a mechanical cable connected to the transmission to measure the vehicle's speed, rather than relying on an electronic sensor. This design was common in many vehicles of that era before the widespread adoption of electronic speedometers.
You may need to replace the speedometer fuse. The speedometer cable can cause your speedometer to stop working. The speed sensor can also cause the speedometer to stop working.
To disconnect the speedometer on a 1992 Toyota Corolla, first, ensure the vehicle is turned off and the key is removed. Remove the instrument cluster by unscrewing the mounting screws and gently pulling it out. Locate the speedometer cable at the back of the cluster, then carefully unscrew or pull off the cable to disconnect it. Reassemble everything once you’ve completed your task.
There is no cable....It's all done with a sensor and electronics.