Look at your error codes again. It should read something like "quad driver module FAULT" not failure. It is VERY unlikely that your quad driver actually died. It is the high power control system that is in your computer. So replacing it, means replace the computer. To prevent this the Quad Driver has all sorts of internal protection hardware in its design. The likely thing that is wrong is something the Quad Driver is connected to. And that The quad driver isn't seeing every thing correctly so thus the Fault. It also can fault if there is a wiring problem from the device to the quad driver. There are Test for each component. You should to to find out which is the problem. Consult your Shop Manual.
The proper tire size for a 1998 Pontiac Transport is P205/70R15. This info is on a sticker placed on the driver's door jam.
Listed in your owner's manual and on the driver's door post.
The fuel filter for most GM vehicles is behind the driver, under the vehicle.
I have a 1990 Pontiac Transport SE, I have the changed the motor on the driver's window which is power...take off the door panel and you will see the motor...not too difficult of a job...follow the old motor route...
look on the sticker on driver door most pop size 205/65/15
I had the same problem on my 1998 Pontica Transport. The solution was to replace the 20 amp fuse under the hood for parking lights.
It Is attached to the driver seat on the left side, or on the floor there is a little lever also on left side of the drivers seat.
Corrected Renewal
How do yo fix a stuck driver side electric window on a 1998 pontiac firebird.
The ECM is located on the driver's side, under the hood on a 2003 Pontiac Montana. It is on the driver's inner fender.
Car transport driver, tireman.
We hired a minibus and driver to transport us safely home from the party.