The problem is probably that the high ration selector is not locating properly with pneumatic shifter. Remove the cover that is held in place with three bolts. Just above the prop shaft. You can then slide the ring assembly along the shaft by hand. Once it is moving in & out & locating correctly. Reassemble the cover taking care to not over tighten the bolts.
They need to have that shape to engage the chian properly
You need to replace your clutch.
Trans. may need a rebuild
when I try to engage gears of mower blades, the engine dies under the load. Read wheels also lock when fowrad and rear gears are engaged.
probably the clutch cylinder is gone :(
cause your stupid
Is the car auto or manual? check fluidlevels first, have you noticed any burning smells prior to problem? Does it not engage in all gears including reverse?
clutch is slipping.
Stick shift or automatic? any other gears work?
Boat trailer winches usually have a small 'L' shaped lever that locks a cog to engage/disengage the drive. These often rust up and are hard to move.
Yes. All automatic transmissions have a hydraulic pump to engage the gears. Saturns are no different in that regard.
The overdrive will not engage on a 97 Mitsubishi Gallant if the switch has been turned off or the transmission is defective. Often time the bands will become worn and prevent it from shifting into certain gears.