On a bracket in front of the pedal up behind the knee roll beneath the steering wheel.
To install a brake light switch on a 1983 Dodge van with a 318 engine, first disconnect the negative battery cable for safety. Locate the brake light switch, typically found mounted on the brake pedal assembly. Remove the old switch by disconnecting the wiring harness and unscrewing it from the mounting bracket. Install the new switch by reversing the process: secure it in place and reconnect the wiring harness, then test the brake lights before reattaching the battery cable.
Check the sensor in the brake reservoir give the float a wiggle. Use a multimeter if necessary if constant low reding is given the switch /sensor is no good.
The 1995 Dodge 1500 RAM pickup truck air conditioning low pressure switch is located on the top of the accumulator.
Take the light out. You might have a bad switch in the door frame. When the door closes- it pushes a switch which I believe opens a circuit and shuts off your light. If the switch is bad it wont open the circuit and the light stays on.
where is the ecu on 1995 bmw 318
it depends on the modification
318 ? what? need more info. 1995 Dodge 1500 318 engine V 8, how many miles does it get?
yes
The ignition switch relay on a 1982 Chrysler New York with a 318 engine is behind the steering column. It is on the inner fender panel.
5.2L/318 cu inch
im not positive cuz i dont have a 318 i have a 325, but i think that is the check engine light... It is actually the tranmission service light.
Not easily. The mounts are different, the manifolds will not interchange, 1986 is carbureted, etc